Industrial water filter working principle
After water filter connected to the piping system, the water from the water inlet into the filter and filtered water flows from the outlet when the impurities in the water through the network core, as the volume is greater than the NET core holes, panties trapped in network core, when accumulated to a certain number, occur through the inlet and outlet have a certain differential pressure. Automatic Backwashing can rotate round the network core and allow the water perpendicular to scour dirt in the filter, drain promptly and thoroughly; network-core structure, avoid the interference of adjacent to the water, impurities will all be discharged from the outlet itself. They do it over and over again.
User selection for electric water filter, the impurities accumulate to a certain number, using differential pressure signal between the cooling water inlet pipe to open the electric drain valve, attached to the inside of the network core-wall reverse flush impurities on the surface of the dirt through the sewage, sewage pipes and sewage discharged into the water valve in the outlet pipe. Discharge step into the rotation, followed by aligning spherical core of each wall, the backwash.
Anti-flush industrial filter water device can alternative two times filter network of small filter water device, can any selected precision, and volume small, cost low, general situation Xia, not must increased power source, just used manual, handles by products Shang by standard of Sentinel location followed by turned, filter water device internal of several filter room can one by one cleaning, to reached automatically recoil filter water in the impurities of purpose. Operation mode of electric control system is divided into automatic mode and manual control mode and debug mode in three.
Industrial water filter installation position and installation type (for example: high input and low output, oblique in-, side-, and so on).